WestwooOne X-Digital Systems XDS Uživatelská příručka stáhnout pdf (Strana 6)

Quick Start Guide, XDS PRO4-P Receiver

Rev J - June 2, 2008

Page 6 of 11

The analog audio outputs for your services appear at the four DB-9 connectors on

the rear panel. Wiring pinouts are the same as on the older Starguide receivers:

AUDIO OUTPUT – DB9M

Pin Signal Signal Pin

1 L+ L- 6

2 GND GND 7

3 - - 8

4 GND R- 9

5 R+

Rule: Each DB-9 connector carries one radio program stream, either mono or

stereo. If the program is mono, the same audio appears on the left and right pin

pairs. In most cases, the left and right sides of a stereo channel are no

longer used to carry unrelated mono programs.

Verify you can hear the test program through all receiver ports.

To manually program the XDS receiver to output the Test Channel on a desired audio

port:

o At the main screen with the network logo, press the SET key, then the left or

right arrows to reach Audio Ports. Press SET.

o Press the left or right arrows to select the Audio Port (letter A, B, C or D).

Press SET.

o Press the left or right arrows to select Program. Press SET.

o Use the up and down arrows to find the Test Channel. Press SET.

1.4 RELAY CLOSURES

There are two DB-37 connectors on the rear panel which together contain a total of 32

mappable relay (or contact) closures to drive your station automation. Relay closure are

momentary Form “A”, rated 500ma @24v.

Your XDS receiver will be delivered with a parts kit including two mating DB-37

connectors with shells.

1 2 3 4 5 6 7 8 9 10 11

Žádné komentáře

WestwooOne X-Digital Systems XDS Uživatelská příručka Strana 6